AI Material Estimator
Say what you are covering (“45 m² of 60×60 tiles, 10% waste” or “walls for drywall, 2.4×1.2 m sheets”). The estimator divides the area by the unit's coverage, adds your waste allowance and rounds up to whole units — for boards and sheets it also reports the linear/plank count. Planning numbers only: verify against the product data sheet and order per the supplier's packing units.
Ask in plain words
The AI reads your question and fills in the parameters; a verified calculator engine does every calculation.
AI interpretation is currently switched off — the manual fields below still give you the exact computed result.
How to use the AI Material Estimator
- Measure the area to cover (length × width per surface, summed).
- Pick the material type and enter the unit dimensions from the product sheet.
- Set waste — straight lay 10%, diagonal/herringbone 15%.
- Press Calculate for whole-unit quantities; cross-check packing units when ordering.
How the calculation works
Unit coverage = unit length × unit width (m²). Net units = area ÷ unit coverage; ordered units = ceil(net × (1 + waste%)). Plank mode divides total area by board width to give linear meters as well. Rounding is always up — you cannot buy a fraction of a tile.
Example questions
- “45 m² floor with 60x60 cm tiles, 10% waste”
- “Drywall for 80 m² of wall using 1.2 x 2.4 m sheets”
- “Deck boards 0.14 m wide over 18 m² with 5 mm gaps”
Related calculators
Prefer doing it yourself? These dedicated calculators run the same verified formulas.
Questions you type are sent to the configured AI provider only to extract parameters; they are not stored. Results are computed locally by deterministic engines and are not advice.