AI Cable Size Assistant

Enter the circuit current, supply voltage, one-way cable run, your maximum acceptable voltage drop (3% is typical for branch circuits) and the conductor material. The assistant computes the minimum cross-section from the voltage-drop limit and rounds up to the nearest standard size. It deliberately does NOT declare the result code-compliant: ampacity, insulation type, installation method, grouping and derating must be verified against IEC 60364 / NEC tables by a qualified professional.

Ask in plain words

The AI reads your question and fills in the parameters; a verified calculator engine does every calculation.

AI interpretation is currently switched off — the manual fields below still give you the exact computed result.

How to use the AI Cable Size Assistant

  1. Enter the circuit current (from the load or breaker rating) and system voltage.
  2. Enter the one-way cable length and your voltage-drop limit.
  3. Pick copper or aluminum — resistivity differs by ~60%.
  4. Press Calculate for the minimum cross-section, then verify ampacity and installation conditions against your local code.

How the calculation works

Voltage drop: single-phase/DC ΔU = 2·L·I·ρ ÷ A; three-phase ΔU = √3·L·I·ρ ÷ A, with ρ_copper = 0.0175 Ω·mm²/m and ρ_aluminum = 0.0283 Ω·mm²/m (conductor operating temperature ≈ 20–40 °C). Required A ≥ 2·L·I·ρ ÷ (V·maxDrop%), rounded up to the standard series 1.5–240 mm². ⚠ Preliminary only: final selection must satisfy ampacity/derating/protective-device coordination per the applicable standard.

Example questions

  • “20 A at 230 V, 25 m run, copper, max 3% drop”
  • “Solar panel to battery 12 A at 12 V, 8 m, 2% drop, copper”
  • “Submersible pump 9 A, 120 m from the panel, aluminum, 5%”

Prefer doing it yourself? These dedicated calculators run the same verified formulas.

Questions you type are sent to the configured AI provider only to extract parameters; they are not stored. Results are computed locally by deterministic engines and are not advice.

Command Palette

Search for a command to run...