The formula behind it
Vout = Vin × R₂ ÷ (R₁ + R₂)- R₁
- the upper resistor (from input to the output tap)
- R₂
- the lower resistor (from the output tap to ground)
A voltage divider taps a fraction of the input voltage proportional to the lower resistor's share of the total. It is the most common analog building block — bias networks, sensor scaling, volume pots (a pot IS an adjustable divider). The catch: the formula assumes no output load, and any real load appears in parallel with R₂, dragging the output down. Design rule of thumb: keep the divider current at least 10× the load current.
How to use this calculator
- 1
Enter the input voltage and both resistances in ohms.
- 2
Press Calculate — the output across R₂, the chain current and the R₁ drop appear.
- 3
Set both resistors equal to confirm the output is exactly half the input — the simplest divider there is.
Worked examples
Half supply
R₁ = R₂ across 5 V gives 2.5 V — the classic mid-rail bias.
Sensor scaling
12 V through 10 kΩ + 2.2 kΩ → 2.16 V, safe for a 3.3 V ADC pin.